Activity Stream

Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums
  • Paradox's Avatar
    04-13-2019, 04:33 AM
    I have a Korg NanoKontrol2 (midi audio controller) and a NanoKey2 (midi keyboard controller) that I’m mapping to OSC commands. The NanoKrontrol 2 was...
    0 replies | 131 view(s)
  • MattPadden's Avatar
    04-11-2019, 11:50 AM
    Hi Freddy, Replying to an old thread here, but I had a similar challenge of needing to reroute QLab OSC messages based on the contents of their...
    1 replies | 3379 view(s)
  • MattPadden's Avatar
    04-11-2019, 11:45 AM
    With grateful thanks to Mic Pool for some crucial advice, I have a solution to this. It's reliant on using QLab (Figure53's MacOS 'big brother' to Go...
    1 replies | 147 view(s)
  • elevenses's Avatar
    04-11-2019, 02:14 AM
    Thanks for your reply. It turns out that I was using the correct button but was only sending data on key press, nothing on release. Now works fine....
    2 replies | 192 view(s)
  • MattPadden's Avatar
    04-10-2019, 08:50 PM
    Hi, I wish to make an OSC mapping, but only when certain conditions within the incoming message are satisfied. The incoming messages come from...
    1 replies | 147 view(s)
  • camille's Avatar
    04-09-2019, 07:44 AM
    Hello elevenses, Thank you for your interest in OSCulator! I believe you must have used toggle buttons in TouchOSC. In order to trigger...
    2 replies | 192 view(s)
  • elevenses's Avatar
    04-09-2019, 02:37 AM
    Hi, I just bought v3.3.0 of OSCulator and set up a simple TouchOSC layout, a fader and several buttons, that transmits only OSC messages. I...
    2 replies | 192 view(s)
  • The_nik's Avatar
    04-02-2019, 05:28 PM
    The_nik replied to a thread Copy and paste in General
    as an example i need to run a different version the code below every now and again but it will take forever if im to write this in as separate lines....
    1 replies | 198 view(s)
  • The_nik's Avatar
    04-02-2019, 05:21 PM
    The_nik started a thread Copy and paste in General
    Hi there... i am triggering Osc messages on my computer with midi to control an audio mixing desk. i am very slow at this and i presume not very...
    1 replies | 198 view(s)
  • Jordon's Avatar
    04-02-2019, 12:48 PM
    Jordon replied to a thread OSCulator 3.0 is here! in General
    I used to be able to Duplicate (or split, I forget which) a button and invert one of the in/outs so that it would send a midi note when pressed and...
    30 replies | 30219 view(s)
No More Results