Hi all!
I have an irregular behaviour - I'm not sure whether it's a bug report?
This happens only since the last version (I think since version 2.10)
When I create an osculator-file, in which I route the nunchuk data to osc and then set the smoothing value to 5 everything works fine.*
The problem is: When I save this file, restart Osculator and connect again - it doesn't remember the smoothing value 5.*
The number 5 is still written in the field but it smoothes stronger than that and I have to reenter the number 5 each time I restart.
Is anyone else able to reproduce this error?
Thank you and all the best!
I have an irregular behaviour - I'm not sure whether it's a bug report?
This happens only since the last version (I think since version 2.10)
When I create an osculator-file, in which I route the nunchuk data to osc and then set the smoothing value to 5 everything works fine.*
The problem is: When I save this file, restart Osculator and connect again - it doesn't remember the smoothing value 5.*
The number 5 is still written in the field but it smoothes stronger than that and I have to reenter the number 5 each time I restart.
Is anyone else able to reproduce this error?
Thank you and all the best!
Comment