hi there.
i'm trying to speak with my vintage controller jl cooper cs-10. controlling reaper or other daws is pretty simple, but the leds and the display of the cs-10 are working with incoming sysex-messages only (this is an official limitation of the hardware). now i want to use osculator for translating the reaper osc-feedback into sysex-messages for the cs-10 (working), to have visual feedback (not really working).
i was able to switch leds on via sysex and "sometimes" to switch off later, but i'm not able to toggle them reliably? it could be a hardware-limitation too, but i can't find deeper informations for this old controller. or did i misunderstood basic principles of sysex or osculator?
for example the sysex for switching on the track 4-led is F0 15 15 00 03 7F F7 and the message for switching off again F0 15 15 00 03 00 F7 (if it helps). is there an command needed, to "refresh"?
thank you!
i'm trying to speak with my vintage controller jl cooper cs-10. controlling reaper or other daws is pretty simple, but the leds and the display of the cs-10 are working with incoming sysex-messages only (this is an official limitation of the hardware). now i want to use osculator for translating the reaper osc-feedback into sysex-messages for the cs-10 (working), to have visual feedback (not really working).
i was able to switch leds on via sysex and "sometimes" to switch off later, but i'm not able to toggle them reliably? it could be a hardware-limitation too, but i can't find deeper informations for this old controller. or did i misunderstood basic principles of sysex or osculator?
for example the sysex for switching on the track 4-led is F0 15 15 00 03 7F F7 and the message for switching off again F0 15 15 00 03 00 F7 (if it helps). is there an command needed, to "refresh"?
thank you!
Comment