I am trying to trigger Logic Pro X Key Commands using Pads in a Lemur template. These Pads only output CC so I have managed to capture a Pad outputting a CC# on a specific channel.
So far so good. Then I have created a Key Combo in Osculator from this captured message.
So I test the button in Lemur, first time I use it it performs the action the key command is set to trigger. Works fine.
But after that it no longer works, I can see the CC coming into Osculator but the message is no longer triggering into Osculator.
If I wait a few minutes, it works again but only momentarily.
Have tried in Osculator 3.1.2 and the 3.2 Beta. Using Logic Pro 10.4, Lemur on iPad via an iConnect Midi device.
So far so good. Then I have created a Key Combo in Osculator from this captured message.
So I test the button in Lemur, first time I use it it performs the action the key command is set to trigger. Works fine.
But after that it no longer works, I can see the CC coming into Osculator but the message is no longer triggering into Osculator.
If I wait a few minutes, it works again but only momentarily.
Have tried in Osculator 3.1.2 and the 3.2 Beta. Using Logic Pro 10.4, Lemur on iPad via an iConnect Midi device.
Comment