PDA

View Full Version : Change treshhold of a Midi Control Change command



harald8515
09-16-2009, 02:56 PM
Hi


I've connected my audio mixing desk to my computer via midi. With the mixing desk I send Midi Control Change commands when I move channel faders. I see in OSCulator that the command are being recieved. I've assigned control change commands to Key Combos. That works so far.

When I monitor the fader action in Quick Look I see that the key combo is being activated when the value increases over 0.5. That equates to -15dB on the fader of my mixing desk. I would like to confgure OSCulator that this treshold value is much less than 0.5. Could somebody help me?


Thanks.

camille
09-16-2009, 11:13 PM
Hi Harals,


This is easy to do with a bit of experiment:

- Open a Quick Look window and switch to the scalings view.

- Locate the incoming midi message, and change the parameter in the "In. max" to something lower.


For example, if you change it from 1 to 0.5, the trigger threshold will change from 0.5 to 0.25.

Try with some values until you reach the desired behavior.


Best Regards,

Cam

harald8515
09-17-2009, 08:31 PM
Hi


Many thanks for your quick answer. I'll try it the next time when I have this mixing desk available.