If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
There is a Motion Plus Reset event that allows you to zero the output.
To use it, press a button and assign this event to the message you just created.
Alternatively, if you want to use that event from an OSC message, all you have to do it send that message to osculator, and again, assign the Motion Plus Reset event to that message.
All of this will be documented just after the final 2.9 release.
Comment