SW Versions
OSCulator 2.8.8
TouchOSC 1.4.2
OS X 10.5.8
iPhone 3GS 3.1.2
I've successfully installed all relevant components to enable comms between TouchOSC and OSCulator. I've setup the necessary networking configurations as described in tech notes and forums, which worked fine and I have been able to 'pair' TouchOSC with OSCulator over my wireless network, each end detects the other end no problem.
However, although I have good network connectivity I *do not* see any evidence of MIDI signals being detected by OSCulator. I've used the default templates provided without any sign of the signal coming through when using faders or buttons in TouchOSC.
Are there any areas I should investigate further apart from:
- Setting up standard network between two end points over 8000 and 9000
- Adding static route using IP address rather than localhost name
Thanks in advance..
Comment