Announcement

Collapse
No announcement yet.

First steps

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • First steps

    Hi Folks,

    I've got some very basic questions so I hope this is the place to ask them. I have contacted Hexler and haven't received a response but I'd really like to get started. I am a retired data analyst who used to DJ on the side and did a lot of layouts and programming using Lemur to control my lighting. I had fairly complex layouts and controlled ENTTEC based products DMXIS and Show Buddy. I am trying to get a handle on TouchOsc but just about all of the setup tutorials land on Abelton Live. If I can get to a place where buttons I click or sliders I move, send out MIDI that I can see in either Protocol or MIDI Monitor (I'm on a MacBook Air with an iPad Pro) I would be golden.
    But the setup is wrong somehow! I am running TouchOsc Editor and TouchOsc Bridge on the Air and have TouchOsc Generations on the iPad which consists of TouchOsc and Osc.
    If I run TouchOsc Editor on the Air and Touch Osc on the iPad the Editor layout will appear on the iPad but no messages MIDI/OSC get to the Air.
    If I run TouchOsc Editor on the Air and Osc on the iPad I can't get the iPad to connect to the Editor to download the Editor layout but any of the example layouts on the iPad will send messages just fine to the Air! I have tried every configuration of the Air IP address with suffixes, 192.168.1.109:8000 but I keep getting "Download Failed" on the iPad.

    I am baffled and confused by this and any help would be greatly appreciated!!!

    Thanks,

    Joe B







  • #2
    Hi Joe,

    I'm sorry but this forum only offers guidance on OSCulator.
    You may want to try hexler's forums.

    Best,
    Cam

    Comment

    Working...
    X