[COLOR=#]Hi,
I've not been able to find any definitive answers on this, so though I'd ask! Some of it is not 100% osculator but I wondered whether you might know the answer anyway?
I've got 3 ipads which I'm able to use with Logic X; 1 as TouchOSC's 'LogicPad', 1 as a home made TouchOSC CC fader command (8 or so cc faders only) and one as a keyboard command grid that runs through Osculator. Each ipad is doing a different task to the others.
I can set them up individually using the default ports 7000 and 9000 (8000 for osculator) and it all works well.
I ran into a few problems when trying to get all 3 working at once though.
What's the correct/best way to sort out ports? If I have multiple ipads with the same incoming and outgoing ports, that seems to cause a few problems. Should I renumber for each ipad?
If so, I've found that the LogicPad template requires the default numbers as re-numbering inside the Logic control surface window and the TouchOSC settings results in most things not working. Having my cc template on different numbers seems to work quite well albeit with some latency.
I'm also running into osculator 'misfiring' when buttons are pressed. When I press any of the 'key combos' via the ipad, 25-40% of the time it sends commands from some of the other buttons too. It seems to happen more as the gap between pressing buttons decreases (fast tapping results in huge numbers of wrong commands being sent). Could this be to do with the ports? Any ideas if not?
Thanks very much!
Jonik
[/COLOR]
I've not been able to find any definitive answers on this, so though I'd ask! Some of it is not 100% osculator but I wondered whether you might know the answer anyway?
I've got 3 ipads which I'm able to use with Logic X; 1 as TouchOSC's 'LogicPad', 1 as a home made TouchOSC CC fader command (8 or so cc faders only) and one as a keyboard command grid that runs through Osculator. Each ipad is doing a different task to the others.
I can set them up individually using the default ports 7000 and 9000 (8000 for osculator) and it all works well.
I ran into a few problems when trying to get all 3 working at once though.
What's the correct/best way to sort out ports? If I have multiple ipads with the same incoming and outgoing ports, that seems to cause a few problems. Should I renumber for each ipad?
If so, I've found that the LogicPad template requires the default numbers as re-numbering inside the Logic control surface window and the TouchOSC settings results in most things not working. Having my cc template on different numbers seems to work quite well albeit with some latency.
I'm also running into osculator 'misfiring' when buttons are pressed. When I press any of the 'key combos' via the ipad, 25-40% of the time it sends commands from some of the other buttons too. It seems to happen more as the gap between pressing buttons decreases (fast tapping results in huge numbers of wrong commands being sent). Could this be to do with the ports? Any ideas if not?
Thanks very much!
Jonik
[/COLOR]
Comment