Results 1 to 6 of 6

Thread: Is it possible to program 'Record' command on Logic Pro

  1. #1

    Volume, pan, and mute all seem to be working fine, just wondering if Record is possible?


  2. #2

    I don't know if there is any possibility to set a MIDI message for Record.

    However you can surely assign a Key Combo.

  3. #3

    yes there is a way, make a Push Button( or use existing one) in touchOSC, give it a KeyCode event type in OSCulator, chose value Key 15, or a latter R. u don't need to assign anything. Done. Simple as that ))

  4. #4

    It's actually a little easier than that.

    1. With touchOSC and OSCulator running, start Logic 9

    2. Then open the Key Commands window (Option-k or Preferences->Key Commands)

    3. In the Key Commands window, open the Global Commands section.

    4. Select the first command you want to map to TouchOSC

    5. Click the "Learn New Assignment" button in the lower right corner of the window.

    6. Then touch/move/etc the control in TouchOSC.

    7. This does not replace the current mapping but just adds the TouchOSC one.

    Just repeat steps 4-6 for every key command you want. For instance, in the Mix 16 template, I mapped the 5 buttons at the bottom of the first page to:

    1. Back to Beginning

    2. Stop

    3. Play

    4. Pause

    5. Record



  5. #5

    Thanks Mark!

    Just to make things a bit clearer, I understand that you solution requires to assign Key commands to TouchOSC buttons in OSCulator beforehand.

  6. #6

    Hey and has someone been able to srcub with touchosc abd osculator?

Similar Threads

  1. Replies: 8
    Last Post: 08-02-2010, 02:47 PM
  2. Aftertouch ('timbre'?) data not arriving at Live
    By bitbutter in forum General
    Replies: 1
    Last Post: 07-17-2010, 02:49 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts