Hi all,
I am attempting to control this Ardour app via OSC from TouchOSC on an iPod through OSCulator on a Macbook Pro, OS 10.6.8. I have had success using midi commands so I know all is well connected; there must be a problem with my understanding of routing setup or syntax for osc. As I understand it, if I receive a message from touchosc in osculator such as </ardour/transport_start>, it needs to be rerouted to the mixbus app. To do this I then: 1) select "osc routing" under "event type" and "new" in the "value" menu 2) find and chose <localhost:3819 (Ardour)> (3819 is the default port that mixbus listens to when "use osc" is enabled in that app) in the Parameters/OSC Routing tab 3) choose the corresponding number in the "osc routing list below. After closing the Parameters window in theory I should be good to go, right? There's a green light at the message in osculator upon pressing the play button but no response from the app.
Mixbus is programmed to understand, among others, the osc message </ardour/transport_start> as the transport/play command; tried re-entering this in the rewrite address window with no change.
Any suggestions much appreciated. Thanks.
Simon
I am attempting to control this Ardour app via OSC from TouchOSC on an iPod through OSCulator on a Macbook Pro, OS 10.6.8. I have had success using midi commands so I know all is well connected; there must be a problem with my understanding of routing setup or syntax for osc. As I understand it, if I receive a message from touchosc in osculator such as </ardour/transport_start>, it needs to be rerouted to the mixbus app. To do this I then: 1) select "osc routing" under "event type" and "new" in the "value" menu 2) find and chose <localhost:3819 (Ardour)> (3819 is the default port that mixbus listens to when "use osc" is enabled in that app) in the Parameters/OSC Routing tab 3) choose the corresponding number in the "osc routing list below. After closing the Parameters window in theory I should be good to go, right? There's a green light at the message in osculator upon pressing the play button but no response from the app.
Mixbus is programmed to understand, among others, the osc message </ardour/transport_start> as the transport/play command; tried re-entering this in the rewrite address window with no change.
Any suggestions much appreciated. Thanks.
Simon
Comment