I know these have probably been asked many times over, but sometimes it's easier to understand when it's your own questions and not someone else's. So, I have some questions:
1. I have, for example, a button for hotcues in Traktor, on my iPad. How can I get LED feedback on this button? I want it to show cue state, such as lighting up if there is a cue point set. I've already set the output in Traktor to Osculator 8000, but that didn't bring me much further.
2. Is it possible to avoid "jump controls" for faders/knobs? With a hardware fader you have to slide from 100 to 0 to actually reach the value 0. On the TouchOSC fader you press 0 and it instantly jumps from 100 to 0 which sounds bad. Is there any way to avoid this, or is this a limitation of TouchOSC?
1. I have, for example, a button for hotcues in Traktor, on my iPad. How can I get LED feedback on this button? I want it to show cue state, such as lighting up if there is a cue point set. I've already set the output in Traktor to Osculator 8000, but that didn't bring me much further.
2. Is it possible to avoid "jump controls" for faders/knobs? With a hardware fader you have to slide from 100 to 0 to actually reach the value 0. On the TouchOSC fader you press 0 and it instantly jumps from 100 to 0 which sounds bad. Is there any way to avoid this, or is this a limitation of TouchOSC?
Comment