Hello dead community, straight to the chase.
I bought my colleague a standard wii mote for wmc, but it just wont do the work as my previous wii motes.
The difference are that the old one's are with motion plus, whilist this "new" one is without it.
I gave him my old osculator file as well as the traktor mapping to him, it "works" in theory, but not in practice.
What happens is that the angles are in some sort of cycle mode or something, where if i reach the bottom part of the valueframe (0 for example) it will flick around and turn into 127 which is obviously not workable.
So what happens is that when i turn the wii mote to the right it will lower the filter until i reach about 90 degrees, that's where it turns around and goes back towards the 0 point, and then back again. My old one's just keeps on going all the way to the bottom for as long as i turn them!
I've been trying and trying to get this to work, but i just coulndt and neither could i find any solutions to my problems online, So this is my last hope..
Cheers and
I bought my colleague a standard wii mote for wmc, but it just wont do the work as my previous wii motes.
The difference are that the old one's are with motion plus, whilist this "new" one is without it.
I gave him my old osculator file as well as the traktor mapping to him, it "works" in theory, but not in practice.
What happens is that the angles are in some sort of cycle mode or something, where if i reach the bottom part of the valueframe (0 for example) it will flick around and turn into 127 which is obviously not workable.
So what happens is that when i turn the wii mote to the right it will lower the filter until i reach about 90 degrees, that's where it turns around and goes back towards the 0 point, and then back again. My old one's just keeps on going all the way to the bottom for as long as i turn them!
I've been trying and trying to get this to work, but i just coulndt and neither could i find any solutions to my problems online, So this is my last hope..
Cheers and
Comment