I am not getting any accelerometer readings from my wiimote. When looking at the "Quick Look", the reading stays constant even though I am moving the remote. Right now only "Pitch, Roll, Yaw" is checked under outputs. MotionPlus is set to continuous mode, though I do not have motion plus, so assume this has no affect.
I was able to install and connect to the wiimote with out any problems. When I press the the buttons, I see the yellow or green active square and am able to get readings in the quick look as well. The "pry" section of the message gives an active box but the individual pitch roll yaw and accel are not lit, though they are checked as being active.
Thanks!
Comment