I made a project where I use TouchOSC with faders and buttons to control an Arduino Due.
Now I'm adding a Korg NanoKontrol2 USB MIDI device through Osculator, to create MIDI to OSC Bridge for extra hardware faders and knobs.
All is working fine technically, but as soon as I move a fader on the MIDI panel.
Way too many OSC commands are updated to the Arduino over the network , causing chokes and it keeps changing updates long after the fader has stopped moving.
Is there any way in OSCulator to limit the amount of OSC output updates/sec?
I updated the Arduino from Mega2560 to a Due, but it is still too many updates for the ARM processor hardware.
Any help would be most appreciated.
Now I'm adding a Korg NanoKontrol2 USB MIDI device through Osculator, to create MIDI to OSC Bridge for extra hardware faders and knobs.
All is working fine technically, but as soon as I move a fader on the MIDI panel.
Way too many OSC commands are updated to the Arduino over the network , causing chokes and it keeps changing updates long after the fader has stopped moving.
Is there any way in OSCulator to limit the amount of OSC output updates/sec?
I updated the Arduino from Mega2560 to a Due, but it is still too many updates for the ARM processor hardware.
Any help would be most appreciated.
Comment